Self-priming Oil Pump

Mar 31, 2020 Leave a message

Before starting the self-priming oil pump, fill the pump casing with water (or water in the pump casing itself). After starting, the impeller rotates at a high speed to make the water in the impeller channel flow to the volute.


At this time, the inlet forms a vacuum, so that the water inlet check door opens, and the air in the suction pipe enters the pump and reaches the outer edge through the impeller channel. Then it merges with the water from the right return hole and flows along the volute. As the liquid continuously impacts the cascade in the volute, it is strongly stirred and mixed with the air to form a gas-water mixture, and it flows continuously so that the gas-water cannot be separated.


The mixture is peeled off by the tongue at the exit of the volute and enters the separation chamber along the short tube. The air in the separation chamber is separated and discharged by the outlet pipe, while the water still flows to the outer edge of the impeller through the left and right return holes, and is mixed with the air in the suction pipe. Repeatedly circulate in this way to gradually exhaust the air in the suction pipe, so that the water enters the pump and completes the self-priming process.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry