The key part of the fuel injection pump is the plunger. If you compare it to the common syringe in hospitals, the movable stopper is called the plunger, and the syringe is called the plunger sleeve. It is assumed that a spring is installed in the syringe against the column. One end of the plug and the other end of the plunger contact the camshaft. When the camshaft makes a full revolution, the plunger will move up and down in the plunger sleeve once. This is the basic movement mode of the plunger of the fuel injection pump.
The plunger and the plunger sleeve are very precise processing parts. There is an inclined groove on the plunger body. There is a small hole on the plunger sleeve called the suction port. This suction port is filled with diesel oil. When the plunger inclined groove faces the suction port, the diesel oil enters the plunger sleeve and the plunger is moved by the camshaft. When the plunger reaches a certain height, the plunger inclined groove is staggered from the suction port, and the suction port is closed, so that the diesel can neither be sucked nor pressed out. When the plunger continues to rise, the diesel will be pressed, and the pressure of the diesel will be opened to a certain extent. Valves swarm out into the fuel injector, and then from the fuel injector into the cylinder combustion chamber. The plunger discharges a certain amount of diesel each time, only part of it is injected into the cylinder, and the rest is drained from the oil return hole, and the amount of fuel injected is adjusted by increasing or decreasing the amount of drained oil.





