What are the contraindications when using oil pumps?

Jul 31, 2020 Leave a message

1. In use, it is strictly forbidden to add diesel oil to the gear oil for dilution, and do not bake the rear axle and transmission because it affects the winter start, so as to avoid serious deterioration of the gear oil. If this happens, you should switch to a low-viscosity multi-grade gear oil.


2. Don't confuse the classification numbers of engine oil and oil pump. In order to avoid confusion in the calculation standard, it is stipulated that the high grade mark is used for gear oil, and the low grade mark is used for engine lubricating oil. However, the grade number of the old gear oil is lower. It should be noted that the viscosity grades of gear oil and engine oil are not related, and the same model cannot be used mutually. Never use gear oil as engine oil, otherwise serious accidents such as bush burning, sticking of cylinders and sintered piston crowns will occur in the engine.


3. Reasonable use of oil pump is conducive to gear repair and maintenance. Gear oil has a long service life. If single-grade oil is used, different viscosity grades should be used during seasonal maintenance. If the discharged old oil is not within the oil change period, it can be added to the vehicle when the oil is changed again. The old oil should be kept properly to prevent water separation, mechanical impurities and waste oil pollution.


4. Change the oil timely. The oil should be replaced with new oil according to the specified oil change index. When there is no oil quality analysis method, the oil can be changed within the specified time limit. The oil change period recommended by automobile manufacturers is 30000-48000km. When changing the oil, release the old oil while it is hot, and clean the gear and gear box before adding new oil. When refueling, prevent mixing of moisture and impurities.


5. The amount of fuel should be appropriate. The amount of oil should be appropriate, neither too much nor too little. Too much not only increases the oil stirring resistance and fuel consumption, but also may cause the gear oil to mix into the brake drum through the rear axle housing (if the seal is poor) and cause brake failure; too little will cause poor lubrication, excessive temperature, accelerate gear wear, and Adversely affect gear maintenance. The gear oil surface should generally be added to be flush with the lower edge of the gear box oil filler port, and the gear oil tank should be checked frequently for leakage, and the oil seals and gaskets should be kept intact.


Send Inquiry

whatsapp

Phone

E-mail

Inquiry