
The pre-treatment process of product electroplating is very important. The general traditional process uses acid to treat the workpiece, which causes serious environmental pollution and poor working environment. At the same time, the biggest drawback is that the residual acid after pickling and rust removal of complex parts is difficult. Rinse it off. After the workpiece is electroplated, the time is not long, and corrosion appears along the cracks, which damages the surface of the electroplated layer, and seriously affects the appearance and internal quality of the product. After the ultrasonic cleaning technology is applied to the pre-treatment of electroplating, not only can the dirt on the surface of the object and the gap be quickly peeled off, but the sprayed layer of the electroplated parts is firm and will not return rust.
Using the cavitation effect produced by ultrasonic waves in the liquid, the oil stains on the surface of the workpiece can be cleaned, and with an appropriate cleaning agent, the surface of the workpiece can be quickly treated with high cleanliness.
The electroplating process has high requirements for the surface cleanliness of the workpiece, and the ultrasonic cleaning technology is an ideal technology that can meet this requirement. Ultrasonic cleaning technology can replace solvents to clean oil stains; it can replace electrolytic oil; it can replace strong acid etching to remove rust and scale on the surface of carbon steel and low-alloy steel.
A brief introduction to the surface conditions of several common workpieces before electroplating with ultrasonic cleaning technology:
1. Cleaning of polishing paste on the surface of polished parts: Generally, the polishing paste is often blended with paraffin wax. The molecular weight of paraffin wax is large, the melting point is high, and it is solid at room temperature. It is difficult to clean. The traditional method is to clean with organic solvents. Or boiling and washing in high temperature alkaline water has many disadvantages. When ultrasonic cleaning is used, water-based cleaning agent can be used. The surface of the workpiece can be thoroughly cleaned in a few minutes under medium temperature conditions. The common process is: ① soaking → ② ultrasonic cleaning → ③ rinsing with clean water (purified water).
2. Cold-rolled steel plate with oil and a small amount of rust on the surface: Generally, the surface of cold-rolled steel plate has oil, dirt or a small amount of rust. It is easier to clean it, but after cleaning by general methods, a very thin layer of float remains on the surface of the workpiece. Ash, which affects the quality of subsequent processing, sometimes has to be soaked in strong acid to remove this layer of floating ash. The use of ultrasonic cleaning and the addition of appropriate cleaning fluid can quickly and easily achieve a thorough cleaning of the surface of the workpiece, and make the surface of the workpiece have a higher activity, and sometimes even eliminate the acid leaching activation process before electroplating.
3. Workpieces with oxide scale and yellow rust on the surface: The traditional method is to use hydrochloric acid or sulfuric acid to soak and clean. If the ultrasonic comprehensive treatment technology is adopted, the oil and rust on the surface of the workpiece can be quickly removed within a few minutes, and the hydrogen embrittlement problem accompanying strong acid cleaning can be avoided.
After electroplating, various treatments are performed on the coating to enhance various properties of the coating, such as corrosion resistance, discoloration resistance, solderability, etc.
Dehydration treatment: Add a dehydrating agent to the water, such as post-treatment after bright nickel plating.
Passivation treatment: improve the corrosion resistance of the coating, such as galvanizing.
Anti-tarnishing treatment: Add anti-tarnishing agents to the water, such as silver plating, tin plating, imitation gold plating, etc.
Improve solderability treatment: such as tin plating, so the pros and cons of the post-treatment process directly affects the quality of these functions of the coating.





