The Operation of Dental Floss

Nov 21, 2022 Leave a message

1. Cut off a piece of dental floss about 45 cm long (about the length of your arm).

2. Wrap one end of the dental floss around the second knuckle of the middle finger of one hand, about two or three times, to fix the dental floss. Then, at a distance of 25 centimeters, wrap the dental floss around the second knuckle of the middle finger of the other hand, and wrap it two or three times in the same way. In this way, one circle is loosened while the other is circled, and the clean section can be used in turn.

3. Clench the middle finger, ring finger and little finger of both hands tightly, straighten the thumb and index finger, like a child playing with a gun.

4. At this time, turn the palm over so that the palm is outward, the two thumbs are inward and touch each other, and the second thumb and the second index finger are at right angles to see if the floss can be tightened. If possible, the floss is the right length between the middle fingers. If not, it can be readjusted.

5. Thumb to "Like" gesture, with the index finger pointing up, the thumb of one hand and the index finger of the other hand tighten the dental floss together, and pass through the fleshy part of the finger, so that the dental floss is about one centimeter between the two fingers, and at the same time The second finger is straight, nail to nail.

6. Bring the dental floss into the gap between the teeth and slide along the teeth into the gap between the teeth and the gums until it encounters natural resistance. Then tighten the floss against the surface of the teeth and scrape the surface of the teeth in an up and down motion until a "squeak" sound is heard.

7. After scraping one side of the tooth surface, then scrape the other tooth surface of the same gap.

8. When flossing the surface of the teeth, the surface of the teeth should be tightened and slightly "C" shaped. Make the floss contact area cover the entire abutment.

9. When starting to practice dental floss, start from the central front teeth, and then move to the back teeth sequentially until the last side of the last tooth. In other words, slowly move from the front teeth, which are the easiest to get to, to the back teeth.

10. Operate the right anterior teeth area. 12. The anterior teeth of the lower jaw are still matched with a thumb and an index finger. At this time, the index finger is adjusted from top to bottom, and the essential point is to raise the arm of the index finger. The posterior area of the lower jaw, as with the upper jaw, is done with the collocation of the two index fingers.


Send Inquiry

whatsapp

Phone

E-mail

Inquiry