Hydraulic system changes

Jan 11, 2020 Leave a message

Guiding ideology: 1. The pressure depends on the load. 2. The output pressure of the oil pump is inversely proportional to the flow rate.


In the electronic control state, when the external load increases, the system pressure increases. When the system pressure increases, the pressure of the front pump oil flow and the rear pump oil flow entering the rear pump increases, and the computer detects the relevant signal to control the electric ratio The pilot secondary pressure at the valve outlet is also greater.


The former acts on the primary piston and the latter acts on the secondary piston. The two push the piston to overcome the spring force to move to the left, and the piston pushes the spool to the left to overcome the spool. The spool spring force moves to the left to make the spool valve spool in the left position. 


At this time, the oil flow of the AY oil pump can act on the large end of the variable piston through the left position of the spool valve spool, where the oil passage changes from normally closed to normal Open, because the cross-sectional area at both ends of the piston is different, the pressure acting on the large end of the variable piston of the swash plate is greater than the pressure at the small end of the variable piston plunger.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry